Patio Green Turf

Before entering the construction, the flatness, slope and surface appearance of the foundation should be tested, and the dressing measures and requirements should be proposed. Only after the requirements are met, can the construction be entered.

Set the line (measurement), find the center point of the site and the center of the two semi-circles, and according to the three fixing points, set the intersection point of the center line and the edge line, and then determine the exact position of the corner points and lines on the site with the Pythagorean theorem, and then determine the position of the functional points and lines, and pop out with ink or paint line.

The sod moved into the field along the direction of the horizontal edge, and in turn from one end of the vertical edge to the other end of the push, spread, as far as possible to weave the white line on the turf in the position of the functional line, reduce the number of cuts.

Cut the white grass line woven on the outer edge of the  Patio Green Turf and not placed on the position of the functional line, and put it aside for use. If the white line is woven separately, it must be manually cut into the white line width of the corresponding functional line on the site.

Lap 1cm at the joints of the Patio Green Turf, cut it from the center of the lap with a cutting knife, make the grass on both sides as compact as possible, and then trim it with a paper knife.

The bottom of the joint of the sod turned up, each side of the width of the sod turned up about 50 cm, and then the 25 cm wide connection belt along the center of the sod joint spread, the special glue were painted on the bottom of the sod joint and the connection belt, the grass joint coated with a brush brush, brush the width of the glue is 6 cm. The connecting belt is evenly coated with a rubber scraper on the connecting belt. In order to achieve the best bonding effect, fully stir the glue or reverse the packaging bucket several times before use to make the glue evenly mixed. When brushing, apply the glue in the same direction, which is conducive to driving out the air and improving the uniformity of the glue, and enhancing the adhesive force. Drying: After gluing, the glue evaporates naturally. After gluing, it must be left to dry for a period of time, until the solvent evaporates clean, so as to avoid sticky glue layer or bubbling, affecting the bonding quality. The drying time should not be too long, so as not to lose the adhesive layer and produce degumming. When the adhesive layer is dry film (about 5-25 minutes) /25℃ can be bonded. Bonding: When bonding, the turf on both sides should be aligned and bonded to the connecting belt at one time, and it is necessary to press and knock, so that the combined part is closely bonded, do not move back and forth, so as not to affect the bonding effect. If the turf or connection is wet, it needs to be dried for half a day.

After the basic splicing of the Patio Green Turf is completed, pull the wire again to determine the exact position of each functional line and point, cut it with a paper knife, pull out the cut grass strip, put the connecting belt into it, scrape and apply glue, put the white grass line originally prepared back, after bonding, beat it with a rubber mallet repeatedly to make the connecting part bond tightly.